Results 1 to 2 of 2

Thread: TV Cable Coaxial broke off

  1. #1

    TV Cable Coaxial broke off

    Well I was upgrading my house to new RG6 cables and went to unscrew the ones from the television and the coaxial input attatched to the TV's main board broke off (was only soldered on with one bead of solder). Television was a vizio 3D tv under a year old which is to my dismay unable to get any sort of input through a cable coaxial anymore. Since the cost of repair outweighs the cost of buying a new one I am wondering if there is any way to bypass the coaxial through a Digitial converter box and maybe watch my OTA channels through running an HDMI cable from the digital converter box. Does Solid Signal sell anything like this were I could input the signal from my antenna the box would scan and find channels and then I could output the signal through and HDMI cord to the television. Any help would be greatly appreciated.

    EDIT; BTW I don't know if it matters but my setup is an HDB8X antenna with a Winegard 8700 pre amp and an antenna craft rotator on top of my roof.
    Last edited by stu022488; 06-28-2013 at 07:12 PM.

  2. #2
    We do carry the ZAT970a converter box but like all converter boxes it outputs only SD.

    However, we also carry this:Channel Master CM7001 ATSC/QAM/NTSC Digital HD Antenna Tuner CM-7001 from Solid Signal

    which will tune HD antenna signals and put them out over HDMI. I think it is a great choice for you.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts