|
|
05-11-2008, 06:19 AM
|
|||
|
|||
Zinwell SUP-2400 Question ...
Hi, I have been trying for the last 3 weeks to install an AU9 with no luck. I then tried an AT9 and still receive 0 (zero) in the receivers. But before this I was using an triple LNB with no problems. I just notice that the SUP-2400 was not installed! Would this cause the no signal (zero) on the receivers?
|
|
05-14-2008, 01:59 PM
|
||||
|
||||
|
Yes without the B-Band converter you wont get much of a signal. But you should still get signal on our older receivers.
-Mike
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Channel Master Pre-Amp Question | eacalhoun | Your Questions Answered | 2 | 09-06-2008 02:27 PM |
| Ground block installation question | gooberff | Your Questions Answered | 1 | 09-05-2008 02:47 PM |
| Question: Upgrade From 3 LNB to 5 LNB | stanyite | Your Questions Answered | 4 | 01-10-2008 07:15 AM |
| Question about install of Wi-EX YX500/510 | colli020 | Your Questions Answered | 1 | 10-29-2007 09:53 AM |
Linear Mode
